Pre-operation inspection
Whether the shot blaster is excessively worn and needs to be replaced.
Inspect the protective plates, protective wear-resistant sleeves and sealing curtains in the shot blasting room. If it is severely worn or damaged, it should be replaced immediately.
Whether it is necessary to add the abrasion and consumption of pellets.
Check the cables, air pipes, air ducts and pill supply pipes to see if they are intact and damaged.
Machine adjustment preparation
Manually open each mechanism in turn and check if there are any abnormalities.
Place the workpiece on the roller table, and adjust the shot cleaning device, shot supply amount, and projection angle to obtain the best effect.
Full technology
Operators must wear labor protection equipment before starting operations.
During the operation of the workpiece, the operator cannot stand on the roller table to avoid affecting the smooth progress of the work.
The pellets scattered around the machine should be cleaned up in time to prevent the operator from falling.
During the operation of the machine, if there is any abnormality, you should press the emergency stop button in time to stop the machine. Wait until the fault is eliminated before starting the machine again.
If maintenance is required, the main power supply should be cut off before proceeding to avoid danger or accident.
This article comes from
Shot blasting machine manufacturer